Each port can be controlled independently. PoE-Out can be configured under /interface ethernet poe menu. Note: Global setting of ether1-poe-in-long-cable can also affect PoE-Out behaviour on PSE which is powered using a DC connector This is potentially dangerous settings and should be used with caution

Setting it to 'yes' will disable short detection on all poe-out ports. Global setting ether1-poe-in-long-cable feature disables strict input/output current monitoring (short detection) to allow the use of PoE-Out with long ethernet cables and/or avoiding improper short-circuit detection. Some MikroTik PoE-Out devices support global PoE setting which can be configured under /interface ethernet poe settings menu. Shows poe-out-status of a specified port, or all ports with /interface ethernet poe monitor command.Дisables PoE-Out power for a specified period of time. RouterOS provides an option to configure PoE-Out over Winbox, Webfig and CLI, basic commands using the CLI areД®xport is displayed under /interface ethernet menu. PoE Configuration is supported on all MikroTik devices with PoE-Out interfaces, the configurations can be edited from the RouterOS and SwOS interfaces. hEX PoE, PowerBOX Pro, CRS112-8P-4S-IN etc.) Note: Some MikroTik devices support all of the described standards (e.g.

hEX PoE, CRS112-8P-4S-IN, CRS328-24P-4S+RM.)Д®ach PoE-Out implementation supports overload and short-circuit detection. MikroTik devices which support af/at standard can also switch to Passive PoE-Out mode. Valid PD should have PoE-In resistance from 23.75kО© to 26.25kО©. MikroTik PSE with af/at support is capable of powering both a Type 1 and a Type 2 PD. The aim of these standards is to reduce incompatibility between vendors.

IEEE Standards 802.3af/at - Also called PoE Type 1/PoE+ Type 2, are PoE standards Defined by the IEEE.

PD resistance on spare pairs should have range from 3kО© to 26.5kО©. Can power up af/at compatible devices, which accepts power over 4,5 (+) and 7,8 (-), and does not require PoE negotiation. The output voltage depends from the power source connected to PSE.

Passive PoE-Out up to 57 V - Works same as low voltage (up to 30 V) PoE-Out, but is also capable to deliver high voltage over PoE ports.

PoE-Out Standard for devices which supports input voltage up to 30 V. For PoE-out uses the same voltage as supplied to the PSE (Power Sourcing Equipment).

Passive PoE-Out up to 30 V - PoE standard, which does not require negotiation between PSE (Power Sourcing Equipment) and PD (Powered Device).

MikroTik devices can support some or all of the following PoE standards: If a device supports powering other devices using PoE-out, then it is recommended to use at least 18V as the input voltage, except for devices that support multiple output voltages (e.g. RJ45 mode B pinout for power distribution over spare pairs, where the PoE is passed trough pins 4,5 (+) and 7,8 (-). This page describes how PoE-Out ( Power over Ethernet) feature can be used on MikroTik devices with at least one PoE-Out interface.

5.1.2 Models with selectable voltage output.

5.1.1 Models with dependant voltage output.

Como usar mikrotik routeros